According to Speed Fan website, version 4.31 added full support for Winbond W83627DHG chip that is installed on this MB. SpeedFan 4.32 displays the AUX temperature if 125C, system temp is 37C, Core 0 is 32C and Core1 is 32C. Other great apps like SpeedFan are Argus Monitor (Paid), iStat Menus (Paid), Core Temp (Free) and FanControl by Rem0o (Free). The best alternative is Sidebar Diagnostics, which is both free and Open Source. There are more than 25 alternatives to SpeedFan for a variety of platforms, including Windows, Mac, Linux, iPhone and. But sadly it is no longer supported by its devs and has become obsolete. I loved how Speedfan was able to control ALL of my fans, even the ones on my GPU and AIO. It is open-source software written entirely in Perl, and provides a web based interface. It will send alerts when it detects problems. It is designed to monitor the status of network services, servers, and other network hardware. What is an Argus file?Īrgus is a systems and network monitoring application. Its personality and energy level has captured the interest of many herpetoculturists over the years. While an Argus monitor is certainly not for every keeper, especially beginners, it can be a very entertaining and rewarding pet reptile when kept properly. How can I tell if my CPU fan is working Ubuntu? Finally, run sensors command in Linux to see CPU and GPU temperature, including fan speed.Configure sensors by running sudo sensors-detect command.First, install lm-sensors package using package manager.The procedure to find fan speed on Linux is as follows: This option controls the using of low-level AIDA64 features to measure cooling fan speeds via the NZXT GRID+ V2 sensor device. This option controls the using of low-level AIDA64 features to measure temperatures and cooling fan speeds via Corsair Link. This ramps your fans in realtime as load increases. Use those values at idle and full load to set MINTEMP and MAXTEMP respectively, with INTERVAL=1. Use watch sensors to observe sensors under CPU and GPU load. On linux, fancontrol is configured using pwmconfig. Make adjustments to fine-tune /etc/fancontrol and use sudo service fancontrol restart to apply your changes.Run through the prompts and save the changes to the default location.You will have to specify what sensors to use.
0 kommentar(er)
